Best viewed on desktop.
Please use the below filters to narrow down your search according to your required parameters.
You may also sort each column (alphabetic or numeric) by clicking on their header.
|wdt_ID||P/N||Datasheet||Case Style||Description||Torque (in-lbs)||Connector Type|
|1||TRQ-516-08||MY2727||Break-over Torque Wrench 8 in-lbs||8||SMA, 1.85mm, 2.4mm, 2.92mm, 3.5mm|
|2||TRQ-N20-8||MY3253||N-type 8 in-lb calibrated break-over torque wrench, 20 mm||8||N-type|
|3||TRQ-N20.6-8||MY3254||Break-over Torque Wrench 8 in-lbs for N-Type connectors||8||N-type|
|4||TRQ-N34-8||MY3255||Break-over Torque Wrench 8 in-lbs for N-Type connectors||8||N-type|
|wdt_ID||P/N||Datasheet||Description||Connector Type||Indicator Type||Interface Measurement Compliance||Gauge Resolution (inch)||Gauge Calibration Accuracy (inch)||Gauge Repeatability (inch)|
|1||ACUDIAL-N||Set of two dial gages to check correctness of interface mating dimensions of pin from Ref plane Of” N” male and female connector||N||Dial||MIL-PRF-39012 Class 2||0.00||0.00||0.00|
|2||ACUDIAL-BNCTNC||Set of four dial gages to check correctness of interface mating dimensions of pin and dielectric from Ref plane of “BNC” and “TNC” male and female connectors||BNC and TNC||Dial||MIL-PRF-39012 Class 2||0.00||0.00||0.00|
|3||ACUDIAL-SMA||Set of four dial gages to check correctness of interface mating dimensions of pin and dielectric from Ref plane of “SMA” male and female connector||SMA||Dial||MIL-PRF-39012 Class 2||0.00||0.00||0.00|
|P/N||Frequency(GHz) LOW||Frequency(GHz) HIGH||Impedance Ω||Connector Type||Contents|
|KSOLT-63-S+||DC||6||50||SMA||• Short, Open & Load standards (f + m) • Matched Thru standards (f<>f, f<>m, m<>m) • Torque wrench|
|KSOLT-63-N+||DC||6||50||N-Type||• Short, Open & Load standards (f + m) • Matched Thru standards (f<>f, f<>m, m&<>m) • Torque wrench|