|
|
|
|
|
This week I am including for you to discover:
|
- New article: Noise and Signal-to-Noise Ratio (SNR) in a Simple Microwave Front-End
- 5 new Mini-Circuits products
I hope you will enjoy the read and look forward to be of further assistance to you.
|
As always, please feel free to contact us with any questions you may have.
|
|
|
|
|
|
|
During the high holidays of Rosh Hashanah, Yom Kippur, Succoth (Feast of Tabernacles), and Simchat Torah (Rejoicing the Law), our office will be working as follows:
|
- Sunday, Sept 25th – Until 13:00 (Rosh Hashanah - Eve)
- Monday, Sept 26th – CLOSED (Rosh Hashanah)
- Tuesday, Sept 27th – CLOSED (Rosh Hashanah)
- Tuesday, Oct 4th – CLOSED (Yom Kippur – Eve)
- Wednesday, Oct 5th – CLOSED (Yom Kippur)
Please note that only minimal staff will be present for urgent matters.
|
- Sunday, Oct 9th – Until 13:00 (Succoth Eve)
- Monday, Oct 10th – CLOSED (Succoth)
- Tuesday, Oct 11th – Until 16:00 (Succoth)
- Wednesday, Oct 12th – Until 16:00 (Succoth)
- Thursday, Oct 13th – Until 16:00 (Succoth)
- Sunday, Oct 16th – Until 13:00 (Simchat Torah Eve)
- Monday, Oct 17th – CLOSED (Simchat Torah)
Happy New Year from all of us at MCDI 😊
|
|
|
|
|
|
|
|
|
Categories: Amplifiers, Attenuators, Filters
|
When a technical discussion turns to noise, especially with several cascaded components involved, the calculations and terminology should be straightforward, but often they become more cumbersome than necessary. Signal-to-noise ratio (SNR) is another parameter that should be routinely calculated by the designer but that still creates uncertainty. The purpose of this short applications note is to square-up noise, noise floor, bandwidth and signal-to-noise ratio (SNR) in general, and to compute these parameters for a basic, three-component RF front end. Other application notes in this series dive deeper into the cascading of noise figure (NF), P1dB and IP3.
|
|
|
|
|
|
|
|
|
Microwave Gain Equalizer Die
50Ω, 6dB, DC - 28000 MHz
|
|
EQY-6-283-D+ is an absorptive Gain Equalizer Die fabricated using highly repetitive GaAs IPD MMIC process incorporating resistors, capacitors and inductors having negative insertion loss slope. EQY-6-283-D+ has a nominal attenuation slope of 6.0 dB.
|
|
|
|
|
|
|
|
Suspended Substrate Band Pass Filter
2000 - 18000 MHz, 50Ω
|
|
Mini-Circuits’ Suspended Substrate Stripline filters offer low insertion loss by implementing printed circuit board suspended between two parallel ground planes, providing high Q. Low insertion loss combined with wide stopband makes them an excellent choice for wideband instruments and systems like ECM, ECCM, ELINT and ultrabroadband receivers. Low pass, high pass, band pass, band stop, diplexer and multiplexer designs can …
|
|
|
|
|
|
|
|
3X Die Multiplier
50Ω, Output Freq 10000 - 22000 MHz
|
|
Mini-Circuits’ CY3-223-DG+ is an ultra-wideband MMIC Frequency Tripler, converting input frequencies from 3.33 to 7.33 GHz into output frequencies from 10 to 22 GHz. Its wide output range makes this model suitable for broadband systems as well as a wide variety of narrow-band applications. The CY3-223-DG+ die utilizes GaAs HBT technology and is suitable for chip and wire assemblies.
|
|
|
|
|
|
|
|
Absorptive SP8T, Solid State Switch
100 MHz - 18 GHz, 50Ω
|
|
Categories: Switch Matrices
|
Mini-Circuits’ USB-1SP8T-183SP is a fast switching solid-state SP8T covering an ultra-wide bandwidth, from 0.1 to 18 GHz. The solid-state design features an impressive combination of high isolation, low insertion loss and good linearity across the entire band. The switch is supplied in a low profile package with SMP connectors, for fast push-fit connections. The daisy-chain control interface with “dynamic addressing” …
|
|
|
|
|
|
|
|
Ceramic Balun RF Transformer
2400 - 7200 MHz, 50Ω, 1:2 Ratio
|
|
|
|
|
|
|
|
|
Tel: 03-7988118
Mobile: 054-4600801
|
|
|
Tel: 03-6736696
Mobile: 054-2008813
|
|
|
|
Our Engineering Team is here to help you!
|
MCDI, Mini-Circuits Exclusive Representative in Israel, hosts a professional team of Application Engineers with decades of experience. Our Engineers are here to assist with identifying the products that are just right for you, advise on correct setups and solutions. They are just a phone call or an email away and also will be delighted to meet you at your location throughout Israel. You may call them directly by clicking on their picture or visit our support page.
|
|
|
|
Mini-Circuits Israel is hiring
We have three great positions available to join our growing team.
|
|
If you know anyone that could be interested, we would appreciate you forwarding this. For your convenience, you may also share directly from our Career page.
|
|
Check the positions by clicking on one of the links below.
|
|
|
|
|
|
|
|
LATEST VIDEO
|
|
Mini-Circuits has over 30 years of experience supporting customers with screening requirements for space missions. From the earliest government missions to the newest commercial SmallSat constellations, our in-house capabilities offer the speed, flexibility, reliability, and cost-effectiveness to make your mission a success.
|
|
Subtitles: English & Hebrew
|
|
LATEST PRODUCT CATALOG
|
|
|
|
|
|
|
|
|
